If you will remember after installing a new transmission and fixing the cracked intake manifold, we found a low end knock in the Pickles 455 motor 
The decision was made to pull the motor and rebuild the bottom end of the motor which is called a “short block” rebuild.
The heads are removed from the motor then the block is completely stripped to be cleaned out 
The block and crank were then taken to our machine shop where it was resized to .020/.020. It came from a 20,000 mile Jasper build at .010/.010 
Next the 20 over bearing sets came in 
and with the block line bored we should get it all back for assembly by the end of the day..
I even greased the wheels with donuts….. hey, whatever it takes….
I think Mikey likes them!
Just wanted to get this up… probably do more later…… isn’t this fun!.
